RCA Victor Tube Radio, Huge Quartz, Huge.
Rca victor radio 1ax2 manual#
If an asterisk (*) appears opposite the tube set-up, this means that an inter-connection exists in the tube which cannot be isolated with lever switch "L". 19191953 RCA Radio SERVICE MANUAL CD ''ALL THE MODELS LISTED ARE ON THIS CD'' ALSO. The meter should read in the "GOOD" on the right side of the meter scale if continuity exists.ġ5. If it is desired to check a tube for filament continuity ONLY then pull the "FUNCTION" switch to position marked "FILAMENT CONTINUITY". NOTE: on many types having two entries it is only necessary to move the SELECTOR SWITCH "R".ġ4. Set controls as indicated and proceed to test again. Tubes having two or more entries on the set-up require more than one test. REJECT THE TUBE IF THE POINTER JUMPS INTO THE RED AREA OR STAYS IN THE RED AREA.ġ3. RCA Victor Clock Radio (1960s) 90.00 (Sold Feb 2011) RCA Creighton 6-X-8 (1955) 85.00 (Sold Nov 2012) RCA Cunningham C12 Radio Tubes 100.00 (Sold Jan 2007) RCA Deco Coin Operated Radio 95.00 (Sold Dec 2007) RCA Direction Finder 60. A good tube should read in the "GOOD" area at the left end of the meter scale. Push the "Function Switch" forward to the position marked "GCT SHORTS AND LEAKAGE" and tap the tube gently. REJECT THE TUBE IF IT READS IN THE RED "REPLACE" area.ġ2. Place the cap clip on top of the tube if one is used.ġ1.Ěs the tube warms up the meter pointer will gradually read into the "GOOD" area on the right side of the scale.
The one at the tipper left is only used when indicated in the tube set-up.ġ0. 54 I I 0 300DD OFFICIAL RADIO SERVICE MANUAL RCA -VICTOR, INC. "L" = Leave in "normal" unless indicated by X, Y, or Zĩ. esries Circuit Data 128 Model Nine - 126 Eleven Tube ModeL 129 CROSLEY RADIO CORP. Locate the tube to be tested on the set-up card.Įxample: Tube Type = 6AU4 -> Fil. CAUTION: DO NOT INSERT THE TUBE INTO ITS SOCKET UNTIL ALL CONTROLS ARE PROPERLY SET UP.ħ. Adjust control on the panel marked "Line Adjust" with a small screwdriver,Ħ.
The meter pointer should rise to renter scale to the mark labeled "LineĪdjust". Allow a half minute for the tester warm up.ĥ. Push the slide switch to "ON" position.Ĥ. Set the Switch "L" to position marked "NORMAL"ģ. Set the "Function Switch" to its mid-position.Ģ. Sort columns values by clicking their titles - A → Z or Z → A IDġ. Select or type a tube name to get specific settings for the Eico 635 Tube Tester.